BIGTREETECH

BIGTREETECH TMC5160T Plus Stepper Motor Driver

$60.00
Tax included. Shipping calculated at checkout.

Apply
Type: With Case

Pickup availability at Regents Park Warehouse/Service Center

In-Store, Order now and collect anytime.

Pickup Availability
  • Regents Park Warehouse/Service Center
    In-Store, Order now and collect anytime.

    6 Rose Crescent
    Regents Park NSW 2143
    Australia

    (02) 9772 4315

Shipping & Returns
  • One Year National Warranty
  • Support by Bambu LabAuthorised Service Center
  • Free shipping over $99 (excludes 3D printers)
Type

Drive big motors hard without lost steps. The BIGTREETECH TMC5160T Plus is an external high-current stepper motor driver built on the TMC5160-TA chip, for machines with larger, more demanding motors.

What you get

  • Power for large motors. Up to 10.6 A RMS (15 A sine peak) from an 8–56 V supply. BIGTREETECH has tested it with 36, 42, 57 and 86 frame stepper motors.
  • Lower heat. Eight separately mounted MOSFETs, each rated 100 V / 93 A, and an integrated heatsink with mounting holes for a fan.
  • Quiet or strong, your choice. StealthChop and SpreadCycle modes are selectable.
  • Connects to your mainboard. Adapters and cables are included for standard driver sockets and EZ driver sockets.

Compatibility

  • Mainboards: BIGTREETECH shows it wired to the SKR 3 (standard driver adaptor) and Octopus MAX EZ (EZ driver adaptor).
  • Firmware: Marlin 2.0 or later for TMC5160 SPI mode, or Klipper.
  • This listing: the version with case, 64 Γ— 56 Γ— 32.55 mm.

Good to know

  • The driver adaptors support 24 V only on the mainboard side.
  • In Klipper set sense_resistor to 0.022 (the default is 0.075); in Marlin set RSENSE to 0.022.
  • Above 3 A, add active cooling. There is a 24 V always-on fan header on the board.
  • Switch power off before connecting, check polarity, and do not remove the factory heatsink.
  • Power the driver before the mainboard logic.

Stocked in Sydney by 3D BRO.