BIGTREETECH
BIGTREETECH TMC2240 V1.0
Pickup availability at Regents Park Warehouse/Service Center
In-Store, Order now and collect anytime.
-
Regents Park Warehouse/Service Center
In-Store, Order now and collect anytime.6 Rose Crescent
Regents Park NSW 2143
Australia(02) 9772 4315
Shipping & Returns
- One Year National Warranty
- Support by Bambu LabAuthorised Service Center
- Free shipping over $99 (excludes 3D printers)
Quieter motors and smarter diagnostics for your printer. The BIGTREETECH TMC2240 V1.0 is a plug-in stepper motor driver module based on the TMC2240 chip, for mainboards with removable driver sockets.
What you get
- Near-silent movement. StealthChop2 for quiet running, with SpreadCycle available for more dynamic moves.
- Smooth motion. Up to 256 microsteps per full step, with MicroPlyer interpolation.
- Homing without switches. StallGuard4 stall detection supports sensorless homing through the DIAG pin.
- Runs cooler when it can. CoolStep adjusts motor current to the load.
Specifications
| Item | Value |
|---|---|
| Supply voltage | 4.5β36 V DC |
| Motor current | 2.1 A RMS (3 A sine peak); 5.0 A bridge peak |
| Interface | SPI and single-wire UART, plus STEP/DIR |
| Resolution | Up to 256 microsteps |
Compatibility
- For mainboards with plug-in driver sockets that give the driver SPI or UART access.
- Klipper has a dedicated tmc2240 configuration section; BIGTREETECH's wiki gives an SPI example.
Good to know
- Check the orientation before plugging in, and fit or remove drivers only with the power off.
- Confirm your mainboard and firmware support the TMC2240 before ordering.
Stocked in Sydney by 3D BRO.
