BIGTREETECH
BIGTREETECH SKR MINI E3 V2.0 3D Printer 32 Bit Controller Board Best upgrade for Ender 3
Pickup availability at Regents Park Warehouse/Service Center
In-Store, Order now and collect anytime.
-
Regents Park Warehouse/Service Center
In-Store, Order now and collect anytime.6 Rose Crescent
Regents Park NSW 2143
Australia(02) 9772 4315
Shipping & Returns
- One Year National Warranty
- Support by Bambu LabAuthorised Service Center
- Free shipping over $99 (excludes 3D printers)
A quieter Ender 3 with a drop-in board swap. The BIGTREETECH SKR MINI E3 V2.0 is a 32-bit mainboard made to replace the original Ender 3 board, with TMC2209 stepper drivers already on board.
What you get
- Drivers included. Onboard TMC2209 drivers in UART mode β nothing extra to plug in or set up on the hardware side.
- No endstop switches needed, if you like. Sensorless homing is built in and switched on with a jumper cap.
- Dual Z ready. A second, parallel Z motor port for printers with two Z motors.
- Room for upgrades. Supports BLTouch, filament detection, the BTT UPS 24V and Relay V1.2 modules, and has two controllable fan ports.
- Runs cooler. Four-layer board with a larger heat-dissipation area under the drivers and a low-resistance heated-bed MOSFET.
Compatibility
- Printers: designed for the Ender 3. BIGTREETECH also lists the Ender 3 Pro, Ender 5, Ender 5 Pro, Ender 5 Plus, CR-10, CR-10 Mini, CR-10S, CR-10 S4 and CR-10 S5.
- Screens: the original Ender 3 LCD12864, or BTT 2.4" and 3.5" TFT screens.
- Power: 12 V or 24 V DC.
- MCU: STM32F103RCT6 (ARM Cortex-M3).
Good to know
- With sensorless homing enabled on an axis, you cannot use a physical endstop on that axis.
- BIGTREETECH supplies Marlin firmware and example configurations on GitHub; you set it up for your own printer.
- After flashing new firmware, restore defaults and then store settings.
- Board size 100.75 Γ 70.25 mm.
Stocked in Sydney by 3D BRO.
