BIGTREETECH

BIGTREETECH Manta M8P Control Board

$105.00
Tax included. Shipping calculated at checkout.

Apply

Pickup availability at Regents Park Warehouse/Service Center

In-Store, Order now and collect anytime.

Pickup Availability
  • Regents Park Warehouse/Service Center
    In-Store, Order now and collect anytime.

    6 Rose Crescent
    Regents Park NSW 2143
    Australia

    (02) 9772 4315

Shipping & Returns
  • One Year National Warranty
  • Support by Bambu LabAuthorised Service Center
  • Free shipping over $99 (excludes 3D printers)

Enough motor outputs for a big Klipper build, without a separate Raspberry Pi. The BIGTREETECH Manta M8P is a 32-bit, 8-axis mainboard made for Klipper, with a socket that takes a CB1 or Raspberry Pi CM4 core board directly.

What you get

  • Mainboard and Klipper host in one. Plug in the core board and skip the wiring between a Pi and the mainboard.
  • Eight driver sockets. For TMC2209, TMC5160, TMC2130 and similar modules; SPI, UART and sensorless-homing (DIAG) pins are set by jumper.
  • Flexible fans and sensors. 24 V, 12 V or 5 V for the controlled fans with no external converter, four-wire fan ports that suit water cooling, and a proximity-probe port for NPN or PNP sensors.
  • Input shaping ready. An SPI expansion port for an external accelerometer.
  • Built to be serviced. Protected thermistor circuit and a replaceable fuse.

Compatibility

  • Core boards: BIGTREETECH CB1 or Raspberry Pi CM4 β€” one is required to run Klipper.
  • Power: 12 V or 24 V DC.
  • MCU: STM32G0B1VET6, 64 MHz.
  • Temperature sensors: 100K NTC thermistors, with PT1000 selectable by jumper.

Good to know

  • The CB1 cannot be connected to the Pi TFT screen β€” use an HDMI5 or HDMI7 screen with it.
  • PT1000 through the onboard circuit is less accurate than a MAX31865 amplifier.
  • MCU firmware updates by SD card or by DFU with Klipper's make flash.
  • Manual and firmware: github.com/bigtreetech/Manta-M8P

Stocked in Sydney by 3D BRO.