BIGTREETECH

BIGTREETECH Manta M4P Control Board

$75.00
Tax included. Shipping calculated at checkout.

Apply

Pickup availability at Regents Park Warehouse/Service Center

In-Store, Order now and collect anytime.

Pickup Availability
  • Regents Park Warehouse/Service Center
    In-Store, Order now and collect anytime.

    6 Rose Crescent
    Regents Park NSW 2143
    Australia

    (02) 9772 4315

Shipping & Returns
  • One Year National Warranty
  • Support by Bambu LabAuthorised Service Center
  • Free shipping over $99 (excludes 3D printers)

A Klipper printer with one board and far less wiring. The BIGTREETECH Manta M4P is a 32-bit, 4-axis mainboard built for Klipper: plug a CB1 or Raspberry Pi CM4 core board straight into it and you no longer need a separate Pi wired to the mainboard.

What you get

  • Mainboard and Klipper host in one. The board-to-board connector takes a CB1 or CM4 and can be secured with screws.
  • Pick your own drivers. Four driver sockets (X, Y, dual Z, E0) for TMC2209, TMC5160, TMC2130 and similar modules, with SPI, UART and sensorless-homing (DIAG) pins set by jumper.
  • Plenty of connections. Three USB 2.0 ports, Ethernet, 40-pin GPIO, BLTouch, filament runout and RGB ports.
  • Protection built in. ESD protection on USB and Ethernet, a protected thermistor circuit and a replaceable fuse.

Compatibility

  • Core boards: BIGTREETECH CB1 or Raspberry Pi CM4 β€” one is required to run Klipper.
  • Power: 12 V or 24 V DC.
  • MCU: STM32G0B0RE, 64 MHz.
  • Board size: 160 Γ— 95 mm.

Good to know

  • The DSI and CSI ports work with the CM4 only. Ethernet runs at gigabit speed with a CM4 and 100 Mbit with a CB1.
  • The CB1 cannot be connected to the Pi TFT screen.
  • MCU firmware updates by SD card or by DFU with Klipper's make flash.
  • Manual and firmware: github.com/bigtreetech/Manta-M4P

Stocked in Sydney by 3D BRO.