BIGTREETECH

BIGTREETECH EBB 36/42 Can Bus for Connecting Klipper Expansion Device Support PT1000

$24.99
Tax included. Shipping calculated at checkout.

Apply
EBB Model: EBB36 CAN V1.2

Pickup availability at Regents Park Warehouse/Service Center

In-Store, Order now and collect anytime.

Pickup Availability
  • Regents Park Warehouse/Service Center
    In-Store, Order now and collect anytime.

    6 Rose Crescent
    Regents Park NSW 2143
    Australia

    (02) 9772 4315

Shipping & Returns
  • One Year National Warranty
  • Support by Bambu LabAuthorised Service Center
  • Free shipping over $99 (excludes 3D printers)
EBB Model

Run one small cable to your toolhead instead of a thick bundle of wires. The BIGTREETECH EBB36 CAN V1.2 is a toolhead board for Klipper that sits on a 36 mm pancake extruder motor and connects back to the printer by CAN bus or USB-C.

What you get

  • Much simpler wiring. The extruder motor, hotend heater, thermistor, fans, endstop, probe and RGB all plug in at the toolhead.
  • Extruder driver built in. On-board TMC2209 running in UART mode.
  • Input shaping without extra parts. On-board ADXL345 accelerometer.
  • Built-in protection. Reverse-polarity protection on the power input and flyback diodes on the heater and fan outputs.

Which version?

Version Temperature sensors
EBB36 CAN V1.2 100K NTC or PT1000 on the thermistor port, plus an on-board MAX31865 for 2-wire or 4-wire PT100/PT1000 (set by DIP switch)
EBB36 CAN V1.2 (without MAX31865) 100K NTC, or PT1000 by fitting a jumper (less accurate than the MAX31865)

Compatibility

  • Firmware: Klipper only.
  • Power: DC 12–24 V. Heater output up to 5 A, two fan outputs up to 1 A each.
  • CAN bus: needs a CAN connection on the host side, such as the BIGTREETECH U2C adapter.

Good to know

  • V1.2 uses the STM32G0B1 chip. Use the V1.2 sample config from the BIGTREETECH EBB GitHub page β€” the hotend pin differs from V1.1.
  • If the board is the last device on the CAN bus, fit the 120R termination jumper.

Stocked in Sydney by 3D BRO.