BIGTREETECH

BIGTREETECH E3 RRF V1.1 Control Board Intergrated TMC2209 3D Printer Parts For Ender 3/5 Pro Upgrade BTT SKR V1.4

$70.00
Tax included. Shipping calculated at checkout.

Apply

Pickup availability at Regents Park Warehouse/Service Center

In-Store, Order now and collect anytime.

Pickup Availability
  • Regents Park Warehouse/Service Center
    In-Store, Order now and collect anytime.

    6 Rose Crescent
    Regents Park NSW 2143
    Australia

    (02) 9772 4315

Shipping & Returns
  • One Year National Warranty
  • Support by Bambu LabAuthorised Service Center
  • Free shipping over $99 (excludes 3D printers)

Control your Ender 3 from a web browser, with quiet drivers already fitted. The BIGTREETECH E3 RRF V1.1 is a 32-bit mainboard for Ender 3-style printers with integrated TMC2209 drivers and an onboard ESP8266 WiFi module.

What you get

  • WiFi built in. With RepRapFirmware you get Duet Web Control in your browser; with Marlin the same module runs the open-source ESP3D web panel. No extra hardware needed.
  • Two firmware paths. BIGTREETECH provides both RepRapFirmware and Marlin builds for this board.
  • Drivers on board. Integrated TMC2209 drivers with sensorless homing, enabled by jumper.
  • Upgrade ports. BLTouch, filament sensors (including the BTT Smart Filament Sensor), Neopixel RGB, auto power-off with the Relay V1.2 and power-loss detection with the BTT UPS 24V.

Compatibility

  • Printers: Ender 3-style machines. BIGTREETECH's pre-compiled firmware targets the standard Ender 3 setup.
  • MCU: STM32F407VGT6.
  • Screens: BTT TFT serial touch screens are supported under both firmwares.

Good to know

  • A standard printer can use BIGTREETECH's pre-compiled firmware.bin; extra features need configuration.
  • With sensorless homing on an axis, disconnect that axis's endstop switch.
  • Under RepRapFirmware, WiFi is set up with G-code commands (M552, M587) after flashing.
  • Manuals and firmware: github.com/bigtreetech/BTT-E3-RRF

Stocked in Sydney by 3D BRO.