BIGTREETECH

BIGTREETECH BTT MAX31865 V2.0 PT100 PT1000 2/3/4 Wires Temperature Thermocouple Module 3D Printer Parts

$17.00
Tax included. Shipping calculated at checkout.

Apply

Pickup availability at Regents Park Warehouse/Service Center

In-Store, Order now and collect anytime.

Pickup Availability
  • Regents Park Warehouse/Service Center
    In-Store, Order now and collect anytime.

    6 Rose Crescent
    Regents Park NSW 2143
    Australia

    (02) 9772 4315

Shipping & Returns
  • One Year National Warranty
  • Support by Bambu LabAuthorised Service Center
  • Free shipping over $99 (excludes 3D printers)

Add a PT100 or PT1000 temperature sensor to your printer by plugging a module into a spare stepper driver socket. The BIGTREETECH MAX31865 V2.0 is a temperature sensor module built on the MAX31865 chip, in the same footprint as a plug-in stepper driver.

What you get

  • Simple installation. It plugs into an unused driver socket, and the sensor wires connect to that socket's motor connector.
  • Works with the common RTD types. 2-wire, 3-wire and 4-wire PT100 and PT1000 sensors.
  • Set it with switches. A 4-position DIP switch selects the sensor type and wiring.
  • Suits 3.3 V and 5 V boards. Accepts 3.3–5 V supply.

Compatibility

  • Mainboards with pluggable stepper drivers that support SPI mode. Boards without SPI-mode driver sockets cannot use it directly.
  • BIGTREETECH's manual covers the SKR V1.1, V1.3, V1.4, V1.4 Turbo, SKR E3 Turbo and Octopus V1.0.
  • The manual covers Marlin, which supports up to two of these modules (heater 0 and heater 1).

Good to know

  • The factory default is 2-wire/4-wire. Using a 3-wire sensor means re-bridging solder pads on the board, or you can run it as 2-wire with slightly reduced accuracy.
  • Marlin needs configuration changes before the module will work, and the listed SKR boards need an extra firmware edit. The steps are in the manual on the BIGTREETECH MAX31865 GitHub page.
  • Disconnect power before wiring or changing the DIP switch.
  • Temperature sensor not included.

Stocked in Sydney by 3D BRO.